SOLD SSS Jonsered 88cc 2186WH

[thinair]

Got a very clean 2186 for sale.
This saw has very low hours
New OEM 55mm jug and piston that Stump Shot ported last year
only has 3 tanks through it since
Double barrel style muffler NON OEM, can come with OEM ported muffler if wanted.
Pro Safety 5 point dogs.
Full wrap husky handle, comes with half wrap heated Jonsered handle
New OEM Husky flip caps with original caps included
OEM momentary stop switch

This saw makes great power, more than other ported 390's I have ran
Squish came in at .017 with no base gasket
Timing advanced 6*

Saw is being sold PHO but an Oregon LW 32 is available.

Asking $1200 usd plus shipping

 

[Roadfxr]

Very very nice redhead!!

 

[redline4]

@Woodrow

 

[stihl livin]

@Woodrow

He said is going to end up broke by the end of the week with all the saws he’s trying to buy. Damn slacker should be working instead of searching for more saws to buy

 

[Woodrow]

@EAK044
@kurtz

 

[Woodrow]

He said is going to end up broke by the end of the week with all the saws he’s trying to buy. Damn slacker should be working instead of searching for more saws to buy

Damn enablers that are looking for saws and sending or tagging me in them!

 

[Stump Shot]

Damn enablers that are looking for saws and sending or tagging me in them!

Who would do such a thing???

 

[redline4]

Wasn't me

 

[Stump Shot]

@Normzilla

 

[stihl livin]

Wasn't me

Me either

 

[Stump Shot]

Here's a vidja of the twin to the cylinder I did for this Jonsered, they were surprisingly identically laid out.
While there is the human factor I would say it should be similar in nature to the 390 that it was built off of.
Edit; There was one difference per request, the squish was set tighter in this cylinder job, than the vid saw.

 

[thinair]

Thanks for the bump Stump!

 

[nacaf68647]

Still for sale ?


Sent from my iPhone using Tapatalk

 

[thinair]

yes

 

[Normzilla]

Here's a vidja of the twin to the cylinder I did for this Jonsered, they were surprisingly identically laid out.
While there is the human factor I would say it should be similar in nature to the 390 that it was built off of.
Edit; There was one difference per request, the squish was set tighter in this cylinder job, than the vid saw.

Impressive and u know I like 390s

 

[Stump Shot]

Impressive and u know I like 390s

Here's a red 390 ready to go...

 

[davidwyby]

I’ll take it.

 

[stihl livin]

I’ll take it.

Why do you need heated handles in the desert

 

[davidwyby]

Why do you need heated handles in the desert

I’m gonna convert it to power the fans in my hard hat

 

[Woodpecker]

I’m gonna convert it to power the jack hammer on my dent puller…

Fix’d