Scrench Holder

[Philbert]

From Leslie Hill - Team Rubicon Chainsaw Operators (edited for length)

For sawyers who stow their scrench in (pack) webbing, here's a simple way to make the attachment a bit more secure.

Slice off a 1/4" wide piece of an old wheelbarrow inner tube, and then replicate what you see in the pics. If the band is a little too long, wrap the band over the top of the scrench before placing the driver tip through the loop.



Philbert

 

[Philbert]

I have a bunch of old bicycle tubes: I suppose that I could cut them on a bias /angle to get the right length band (I use flat-free tires on my wheelbarrow!).

Philbert

 

[Philbert]

This arrived from Amazon. Similar to a mod I did, with spray paint and a length of boot lace, several years back, but factory made, with a 1/2” ID ring welded to the tip, instead of a drilled hole.



Could be a good choice for many folks. Not sure if the welded ring might interfere with some full wrap handles, or digging for deep spark plugs.


(my version)


Philbert

 

[Wonkydonkey]

I like both versions, however I can see that welded eyelet getting in the way on some saws.

Mabe worth trying to weld that eyelet on the underside close to the shaft

 

[Woodpecker]

I like both versions, however I can see that welded eyelet getting in the way on some saws.

Mabe worth trying to weld that eyelet on the underside close to the shaft

It always comes back to the shaft with you doesn’t it Sean!

 

[Wonkydonkey]

It always comes back to the shaft with you doesn’t it Sean!

lol.

Especially yours

 

[Normzilla]

This arrived from Amazon. Similar to a mod I did, with spray paint and a length of boot lace, several years back, but factory made, with a 1/2” ID ring welded to the tip, instead of a drilled hole.

View attachment 461917

Could be a good choice for many folks. Not sure if the welded ring might interfere with some full wrap handles, or digging for deep spark plugs.

View attachment 461918
(my version)


Philbert

Nice setup