SELLING $500 Ported Husky 359 PHO

[farminkarman]

For sale is a freshly rebuilt & ported Husqvarna 359. As you can see in the pics, this isn’t a show queen. I split the cases and put new Nachi 6202-C3 bearings in, and reassembled with a Duke’s gasket set. The original piston was a bit too worn to re-use, so I installed a new meteor slug with caber ring. I cut 0.030” from the squish and and cut the base for 0.020” clearance with no gasket. I opened up the lowers and did 105, 121, 78; advanced the timing, removed the carb limiters, and gave it a generous muffler mod. I also replaced the fuel line with a aftermarket Hyway curly line (couldn’t get a husky one at the time), and I used a 390xp intake clamp. I have only run the saw for a few test cuts to establish a base tune, and it rips pretty good. I would like to get $500 shipped (paypal F&F) to the lower 48.

 

[farminkarman]

 

[ZERO]

Greg is top notch with his work and attention to detail.
If he says it was done, you can be sure that it was done with extreme care.

 

[farminkarman]

Greg is top notch with his work and attention to detail.
If he says it was done, you can be sure that it was done with extreme care.

Thanks Mike

 

[farminkarman]

Figured I would get it out and make a vidya while I had the tractor handy.

 

[farminkarman]

Bump…dropping to $500 shipped.