SOLD MS462 for trade

[Thumper88]

MS462CM purchased April 15th ‘20. Always ran on 93 octane E-free mixed 40:1 with Amsoil Dominator. West coast Bark box muffler cover, also includes stock muffler cover. Includes manual. Timing was advanced by a friend 4 deg. Has a custom 3/4 wrap made from the stock handle and the clutch side cut off an 084 wrap. Not the prettiest but it’s strong and stable. Big dawgs and roller chain catch. Saw has seen approximately 5 gallons of pre-mix. Oiler is turned all the way up and pin has been pushed in. Can come with 2 bars for the right trade, 20” county line bar with Oregon VLX chain and a 28” Stihl ES light bar with two Stihl RS chains. Only trade interest are , a 395XP ported or stock, definitely prefer ported. 064/066 ported or stock, again prefer ported. MS500i. I can add cash to make the deal happen. Just finding that a bigger saw would fit better into my business plan, and I think a ported 395XP would fit the bill perfectly. Pictures coming up.

 

[Thumper88]

 

[Thumper88]

 

[Fullkip]

I have a very low hour 390xpw if interested. It's all stock and has the west coast kit. Probably less than 5 gallons of gas through it...

 

[Thumper88]

I have a very low hour 390xpw if interested. It's all stock and has the west coast kit. Probably less than 5 gallons of gas through it...

I had actually kinda forgotten that 390XP. Sure, send me some
Pictures, I’d like to take a look at it

 

[Coop The Cutter]

Diggin that verse on the air filter, GLW$!!!

 

[Thumper88]

Diggin that verse on the air filter, GLW$!!!

Thanks man. I put that on there the week I bought the saw, and I’ve made some money with that saw and it has all come through sweat and blood