FOUND IT MS440/044 crank

[PA Dan]

Needing a crank for a Stihl MS440 build. Broke the threaded end off when tearing it down.[emoji2959][emoji2959][emoji2959] Let me know what ya got. Got parts to trade and or PayPal ready

 

[beaglebriar]

That's unfortunate [emoji3525].

 

[lehman live edge slab]

Pretty sure I have one for you

 

[blacksmith]

Dan I have an 044 10mm crank that's in very good shape and I think I have a 12mm crank as well. The 12mm crank would have a repair on the clutch side where the e-clip goes to hold on the washer. Let me know if you intrested.

 

[lehman live edge slab]

I had 2 10mm cranks only and he’s looking for a 12 so the search continues

 

[beaglebriar]

Dan I have an 044 10mm crank that's in very good shape and I think I have a 12mm crank as well. The 12mm crank would have a repair on the clutch side where the e-clip goes to hold on the washer. Let me know if you intrested.

I've fixed those up before. A little careful welding and some Dremel work.

 

[blacksmith]

I've fixed those up before. A little careful welding and some Dremel work.

Absolutely. The one that I have on my 044 now has a repair where the e-clip goes on the clutch. Just have to make sure that you preheat before you weld otherwise the weld may break off.

I've been running it that way hard for about 2 years and still holding strong!

 

[PA Dan]

Dan I have an 044 10mm crank that's in very good shape and I think I have a 12mm crank as well. The 12mm crank would have a repair on the clutch side where the e-clip goes to hold on the washer. Let me know if you intrested.

Sorry I missed this buddy! I appreciate you posting! I did find one so I changed the title!

 

[blacksmith]

Ok no problem Dan.