More farmertec additions

[MG porting]

I'm definitely going to be getting the ms880 that's a perfect milling saw for me.lol

 

[ammoaddict]

They did a good job building that saw held up to that throttle being pind wide open for that langth of time.

Maybe they used lots of OEM parts.

Sent from my Moto G (4) using Tapatalk

 

[Nutball]

I would think under load would be much more stressful since the energy would have to fight against a braking torque actually putting strain on the bearings and crank, and heat would be trapped in the cylinder for longer amounts of time at a loaded rpm.

 

[qurotro]

Those chinesium is not about material quality but the quality control that matters.

 

[stihl_head1982]

I would think under load would be much more stressful since the energy would have to fight against a braking torque actually putting strain on the bearings and crank, and heat would be trapped in the cylinder for longer amounts of time at a loaded rpm.

yep, under load I believe the results may certainly be different.
Perhaps they should try to bury it in some hard wood -- (perhaps a 4 foot diameter log of oak or other dense hardwood)

 

[MG porting]

Maybe they used lots of OEM parts.

Sent from my Moto G (4) using Tapatalk

Now you're catching on.lol

 

[Wolverine]

Exciting news for 288 fanboys

Meh, I'm not into making china great.

 

[Oregon]

Don’t give two craps about China, but affordable toys for me to play with.

 

[Jon_C]

Well here is an update!



Note the 046 kit ran a month late, so they might all run a little later than intended. These are the estimated release dates after all.

 

[ammoaddict]

I would do a 288 kit if the price is right.

Sent from my Moto G (4) using Tapatalk

 

[MG porting]

I have not seen the ms460 kit yet. I got tied waiting so I ordered a bunch of parts to build one witch is fine by me because it's got a lot of OEM parts so at least I know it will be reliable.

 

[MG porting]

. Yep here is me eating my words because I just checked there site and yes they do have the ms460 kit now.

 

[ammoaddict]

I wonder if they are experimenting with autotune or mtronic yet.

Sent from my Moto G (4) using Tapatalk

 

[Nutball]

I'd rather they just made needle carb conversions. I wouldn't want to worry about chinese bugs in the electronics too!

 

[ammoaddict]

I'd rather they just made needle carb conversions. I wouldn't want to worry about chinese bugs in the electronics too!

I wouldn't buy one, just wondering if they were thinking about it. The Chinese are very tech savvy, they may even come up with a better system.

Sent from my Moto G (4) using Tapatalk

 

[dustinwilt68]

They are very tech savvy at stealing proprietary technology, fixed it for you. Better off buying a project saw and building OEM imo, full wraps and plastics don't bother me AM, but internals, no thanks.

I wouldn't buy one, just wondering if they were thinking about it. The Chinese are very tech savvy, they may even come up with a better system.

Sent from my Moto G (4) using Tapatalk

 

[cuinrearview]

They are very tech savvy at stealing proprietary technology, fixed it for you. Better off buying a project saw and building OEM imo, full wraps and plastics don't bother me AM, but internals, no thanks.

Lots of projects out there...