SELLING MMWS ms400

[Woodpecker]

I have a MMWS ported 400 here for sale. Full disclosure this saw suffered a minor crush incident. The pto case, rear handle/tank, and handlebar were replaced. Randy did the bulk of the work restoring this saw. I replaced the rear handle/tank after a small leak was found upon return from Randy. Not much more to say other than let the pics tell the tale of condition. This saw has been run its whole life on Amsoil dominator and is good to go. I’m looking for $1300 pho shipped. PM if interested.

 

[Woodpecker]

Moar picz

 

[Woodpecker]

And filter pic for the pervs

 

[larasea]

I have a 400 ported by Randy and its a beast. My go to saw for firewood. Great saw.

 

[whitesnake]

Nice clean exhaust port…

 

[Woodpecker]

Nice clean exhaust port…

Top of the piston when viewed through the spark plug hole as well. Pretty impossible for this hammer donkey to get a good pic of that though. That’s why I’ll continue to run Dominator in all my saws until something else is proven superior. I can’t imagine that happening, but you never know.

 

[cuinrearview]

You coulda at least cleaned the taint smears off the top cover. We’re not savages here.

 

[SawAddictedFarmer]

I have a MMWS ported 400 here for sale. Full disclosure this saw suffered a minor crush incident. The pto case, rear handle/tank, and handlebar were replaced. Randy did the bulk of the work restoring this saw. I replaced the rear handle/tank after a small leak was found upon return from Randy. Not much more to say other than let the pics tell the tale of condition. This saw has been run its whole life on Amsoil dominator and is good to go. I’m looking for $1300 pho shipped. PM if interested.


View attachment 487541View attachment 487542View attachment 487543View attachment 487544View attachment 487545

Moar picz View attachment 487546View attachment 487547View attachment 487548View attachment 487549View attachment 487550

And filter pic for the pervsView attachment 487551View attachment 487552

Nice saw. Your back! GLWS!

 

[Woodpecker]

You coulda at least cleaned the taint smears off the top cover. We’re not savages here.

Saw is being sold as is… Might be a feature for sum.

 

[EFSM]

Top of the piston when viewed through the spark plug hole as well. Pretty impossible for this hammer donkey to get a good pic of that though. That’s why I’ll continue to run Dominator in all my saws until something else is proven superior. I can’t imagine that happening, but you never know.

This thread may turn into a 1k page monster all because of this post.