SOLD MMS 5105H and 5105.

[Armbru84]

@Armbru84 Didn't you say you needed more small saws to even out all the 70+cc saws you have? Heated handle too!

Lol. Righhhhhhhht. Carl is good people that’s for sure. I looked at this add several times.

 

[Miller Mod Saws]

5105H-sold

1 down 1 to go.

 

[RI Chevy]

Bump

 

[Miller Mod Saws]

Bump. I’m gonna knock this remaining saw down to $500 shipped as I just bought a few more. I’ll also include the 18” x 3/8 bar I’ve been using. It’s not pretty but still in pretty good shape.

 

[Miller Mod Saws]

Bump. I’m gonna knock this remaining saw down to $500 shipped as I just bought a few more. I’ll also include the 18” x 3/8 bar I’ve been using. It’s not pretty but still in pretty good shape.

I’m gonna bump this again. And ask @RP81 to give his honest evaluation. As I put a new carb on her and got the opportunity to meet him this weekend. And this is one saw he got to run.

 

[RI Chevy]

Just for clarification, is this saw #1 or saw #2? Its been a while. Lol

 

[Miller Mod Saws]

Just for clarification, is this saw #1 or saw #2? Its been a while. Lol

Amen. This is the non heated handle saw.

 

[sweetjetskier]

The 5105's are great saws gentleman, I owned a 5105H, from new and it was sweet. I needed ching at the time or it would be in CT still, Hooskavarna was a happy man after buying that saw from me.

 

[RI Chevy]

Amen. This is the non heated handle saw.

Thank you sir.

 

[sweetjetskier]

After running the 5105H on a cold New England day, a stop to the Mews Tavern in Wakefield always has been an exceptional way to wrap up a day of cutting....

 

[RI Chevy]

Nice! I am 15 minutes from the Mews Tavern. [emoji106]

 

[sweetjetskier]

The mews has changed a lot over almost 25 years since I graduated from URI, but always a great spot. We try and get there 3-4 times a years from CT. Not many of the checker board / chess butcher block tables left, nonetheless the original bar is where its at

 

[RI Chevy]

Lol. Yup. Big URI hangout for sure. [emoji106]

 

[RP81]

I’m gonna bump this again. And ask @RP81 to give his honest evaluation. As I put a new carb on her and got the opportunity to meet him this weekend. And this is one saw he got to run.

What surprised me the most about this lil fella was the torque it had! It’s a little saw that doesn’t mind if you pull up on the handle!!