- Local time
- 12:24 AM
- User ID
- 10860
- Joined
- Nov 2, 2019
- Messages
- 280
- Reaction score
- 765
- Location
- North Idaho
Hello there folks. I have another very clean Pro Mac I would like to sell. I just serviced this PM700 and have made some test cuts but otherwise I haven't had it very long. The motor is in solid condition, piston looks clean and compression is pretty good. The entire fuel system needed some attention though. I ended up installing a new viton tank gasket, viton cap o-ring, new spacer and insulator gaskets, kit in the carb and did a fuel line fix. The fuel line fix consists of new tygon line, grommet and new weighted filter. The air filter is new but I don't think it's oem, there's no logo or numbers on it. I swapped the clutch needle bearing for a new one. The starter dust cover is a new one I got from the Duke. Everything on the saw works as it should. Cuts pretty good and has a nice sound. Its a good idea to use the decomp as the compression is still pretty good. I would like to get $215 for the pho. I do have most of the components for the chain brake so if you want it let me know. Bar shown in photos is a 24" mac hard tip. I'm open to letting that go with the saw just let me know. Willing to ship to the lower 48 and Canada on your dime. If you think I'm asking too much then make an offer. Thanks
Sent from my SM-N970U using Tapatalk
Sent from my SM-N970U using Tapatalk
