Mahle and KS 024 cylinders...

[PA Dan]

Anyone know of any differences in these two 42mm 024 cylinders? Other than ones dirty and ones clean...

 

[RIDE-RED 350r]

Be interesting to put them both on the degree wheel. I know I saw significant differences between an old KS and Mahle 288 cylinder. Are there any visually obvious differences in the ports Dan?

 

[PA Dan]

No ideas I only have the dirty Mahle. Anyone have a KS that they can post a pic of?

 

[PA Dan]

Here's a pic of the transfers on the Mahle cylinder.

 

[huskyboy]

Anyone know of any differences in these two 42mm 024 cylinders? Other than ones dirty and ones clean...

More “+” marks equal a later version/revision cylinder and less is a earlier cylinder. Not 100% sure so don’t quote me on it. I bet the ks cylinder is off a early saw.

 

[brshephard]

Check out the last four posts in this thread. (It's mahle vs KS 026 cylinders)

http://opeforum.com/threads/ms026-cheapish-rebuild-fix.12696/

 

[Stihlsmoking]

No ideas I only have the dirty Mahle. Anyone have a KS that they can post a pic of?

 

[PA Dan]

View attachment 124016View attachment 124017 View attachment 124018View attachment 124019

Thanks I'll post the same pics of my Mahle cylinder in a couple hours when I get home from work.

 

[PA Dan]

Here's the Mahle cylinder...

 

[RIDE-RED 350r]

Transfers look like they have a little more area with the Mahle

 

[PA Dan]

Rough measurement on the Mahle cylinders lower transfer is 15mm x 23mm...

 

[stihl_head1982]

Rough measurement on the Mahle cylinders lower transfer is 15mm x 23mm...

Get back with us on the smooth measurement.

 

[PA Dan]

Get back with us on the smooth measurement.

Lol!