WANTED Long bar to suit Mac 125

[cm76]

I am chasing a long bar to suit the large McCulloch machines. I am preferably after a 60" roller nose / hardnose bar in .063 gauge.

A 60" sprocket nose bar would also do the job as I have some good sized hardwood to tackle.

Any replies are appreciated.

Chris

 

[Jimmy in NC]

Id try either Cannon or Chain Bar Repairing (www.chainbar.com)

If looking to work it, start out fresh. Long bars that have been tweaked or abused can be miserable.

 

[mdavlee]

Myrtle Creek saw shop. Ask for Rich

 

[jacob j.]

Myrtle Creek saw shop. Ask for Rich

541-863-5387. He probably has more long bars than anyone else on the west cost.

 

[mdavlee]

541-863-5387. He probably has more long bars than anyone else on the west cost.

I was lazy and didn't search for it.

 

[cm76]

541-863-5387. He probably has more long bars than anyone else on the west cost.

Thanks for the replies gents - will give him a call.

 

[sawfun]

You can use a Cannon or Stihl 60" bar with Cannons adaptor rings and by Redhill ingredients the oil holes where you want them. I have done a 60 and 72 inch that way and they work great on my 890 & 895.

 

[cm76]

You can use a Cannon or Stihl 60" bar with Cannons adaptor rings and by Redhill ingredients the oil holes where you want them. I have done a 60 and 72 inch that way and they work great on my 890 & 895.

Hi Don,
Thanks for the information about the bars.
What are you referring to regarding 'Redhill ingredients' ?

Chris

 

[sawfun]

Sorry, I meant re-drill the oil holes. No ingredients. This new phone has a nasty habit of trying to correct legit words and adds new ones in. I failed to proof read it.

 

[cm76]

Sorry, I meant re-drill the oil holes. No ingredients. This new phone has a nasty habit of trying to correct legit words and adds new ones in. I failed to proof read it.

Ok - nice one Don.