Let's See Them Chips !!!!

[Squareground3691]

Part du...
Finished up this section.

On to the next, down the road...View attachment 413727
View attachment 413725View attachment 413726

Ur Taco wheels, sure did stick out from fenders a bit ,

 

[Woodwackr]

Ur Taco wheels, sure did stick out from fenders a bit ,

Hey, I have mudfaps
Well, in the rear...

 

[Squareground3691]

Hey, I have mudfaps
Well, in the rear...

My taco,

 

[Woodwackr]

My taco, View attachment 413837

 

[Squareground3691]

View attachment 413839

Nice

 

[Woodwackr]

Work crew...
Trying out a couple recent builds. 268 is nice, the 372 will wind up being 2nd to Randy's 500. I really like it. Good handling, power.
Dozer Dan 346 still going and pushing 20yrs old now.
Tried the 266...not shown…dismal failure so back it goes for teardown to figure out what I did wrong

 

[Squareground3691]

 

[MAF143]

 

[Steelie90]

chips are flying. Cutting some new mandrels and a chamber

 

[stihl livin]

@Brad Krause
What size chips will this produce

 

[nbbt]

@Brad Krause
What size chips will this produce
View attachment 414489

Zero chips, total barge anchor

 

[MAF143]

The chips from post #388 above helped make the chips in these videos.

 

[Woodwackr]

@Brad Krause
What size chips will this produce
View attachment 414489

Wasn’t that one featured in the last Sharknato movie?

 

[Woodwackr]

The chips from post #388 above helped make the chips in these videos.

No offense…but, my Dozer Dan 346 will do that in that size wood, lol
Maybe a tad faster…

 

[MAF143]

No offense taken. I didn't build it for fast in the little stuff. I built it for my long bars after a few more tanks of mix, but I'm not gonna break it in with a 42" on it. I'm just happy it throws chips and runs better than when I got it. I'm not here to race the pro's.

 

[Woodwackr]

No offense taken. I didn't build it for fast in the little stuff. I built it for my long bars after a few more tanks of mix, but I'm not gonna break it in with a 42" on it. I'm just happy it throws chips and runs better than when I got it. I'm not here to race the pro's.

To go fast in the little wood…18-20” bar, 8 or 9 pin rim…and hang on, lol
36-42 would be my bar choice. Waiting on a few parts for my 288 build.

 

[Hulpio]

Chips from a birch. Died while sleeping yesterday. G5800 still going strong.

 

[WI_Hedgehog]

@Brad Krause
What size chips will this produce?
STIHL 991 XXL

I looked that up just in case.

 

[Wilhelm]

Side milling, 14mm Solid-Carbide mill in cast iron

 

[Wilhelm]

Running my new planer, does well in dry Cornelian Cherry