Husqvarna 61 fuel line grommets

[Ronie]

I read somewhere that someone used a grommet off something and used a regular fuel line for a 61, does anyone know what grommets would work for that?

 

[Czed]

Stihl fs90 I think it was

 

[Ronie]

Stihl fs90 I think it was

Thank you!

 

[Czed]

Thank you!

No problem
I believe many of the stihl trimmer grommets are the same.

 

[Ronie]

I looked at what they cost and I might as well buy the correct fuel lines, that Stihl stuff is expensive.

 

[Czed]

I looked at what they cost and I might as well buy the correct fuel lines, that Stihl stuff is expensive.

The oregon version has been great.

 

[Ronie]

The oregon version has been great.

I'll check them out. I found some cheap ones on Amazon but they are probable like the Chinese fuel lines and break down quickly.

 

[67L36Driver]

Our local Ace hardware has rubber grommets in the yellow bin boxes in their electrical department. Wide range of sizes. [emoji106]

 

[Ronie]

Our local Ace hardware has rubber grommets in the yellow bin boxes in their electrical department. Wide range of sizes. [emoji106]

I think I would need Nitrile grommets and they are probable rubber.

 

[Ronie]

The oregon version has been great.

I found some Oregon fuel lines for $6 shipped and ordered a couple, thanks.

 

[Czed]

I found some Oregon fuel lines for $6 shipped and ordered a couple, thanks.

I've got 4 year's on a few them with ethanol fuel I'm too lazy to drive 10 miles for efree
No failure's
Honestly the china fuel lines haven't failed in the 2 series I bought 20 for like 6.00 one time
Just the 365/372 were trash so far.

 

[Ronie]

I've got 4 year's on a few them with ethanol fuel I'm too lazy to drive 10 miles for efree
No failure's
Honestly the china fuel lines haven't failed in the 2 series I bought 20 for like 6.00 one time
Just the 365/372 were trash so far.

That's good to know, I figured they would be like the 372 fuel lines. I've been buying Rotery bulk fuel line and it's held up pretty good so far.

 

[67L36Driver]

I think I would need Nitrile grommets and they are probable rubber.

I agree likely plain rubber.

I’ve been keeping my fingers crossed as most are above the wet fuel level.

[emoji6]