SOLD Dolmar 6400 pho $350

[psuiewalsh]

This was a project I picked up a couple weeks ago. There is a 6400 thread on here http://opeforum.com/threads/6400-modification-questions.1518/. I replaced the piston and cylinder with an almost new take off from a previous 6401 to 7900 conversion. The intake/throttle cable bracket and impulse line were replaced with new. The chain tensioner set was replaced with new. The muffler is a good used replacement. The squish was set at .020" without a base gasket. It is pushing around 200psi. I have run about 6 tanks through it now and it is running strong. I would like $350 for the saw. Buyer to pay shipping. I have bars separate if you need.

 

[psuiewalsh]

 

[Toad22t]

Keith if this is around in a week or so I'll take it!

 

[Toad22t]

But I doubt it will be!

 

[psuiewalsh]

Ok. Time will tell.

 

[luckydad]

Hey I know that 7900 in the back ground [emoji106][emoji106]


Sent from my iPhone using Tapatalk

 

[psuiewalsh]

Now hacked

Sent from my C771 using Tapatalk 2

 

[exSW]

This is still here?

 

[psuiewalsh]

Yes. Would you like it to stay within state lines?

Sent from my C771 using Tapatalk 2

 

[luckydad]

Now hacked

Sent from my C771 using Tapatalk 2

Very nice !!!
Mike's the man [emoji106][emoji106]


Sent from my iPhone using Tapatalk

 

[exSW]

Yes. Would you like it to stay within state lines?

Sent from my C771 using Tapatalk 2

Love to. But have two other deals working presently. Actually three with the port job. I should be out cutting money right now but it's raining.

 

[Toad22t]

Is this still available Keith?

 

[psuiewalsh]

Yes.

Sent from my C771 using Tapatalk 2

 

[Toad22t]

Yes.

Sent from my C771 using Tapatalk 2

I'll send you a pm!

 

[psuiewalsh]

SOLD pending funds