Any window shaker technitions out ther lol.

[merc_man]

Just put the window ac in bed room and it fired up blowing cold air for about two mins and then compressor turned off. Then herd it try cycling on but no start. Unpluged for five mins and now the fan wont even start.

Sent from my SM-J320W8 using Tapatalk

 

[jakethesnake]

Open the window and kick it out

 

[Fruecrue]

Check the breaker.
Did you turn it on its side at all during transport?

 

[merc_man]

Open the window and kick it out

I wanted to but wifes car is below it.

Might have to use it as a target for the rifle.

Sent from my SM-J320W8 using Tapatalk

 

[merc_man]

Check the breaker.
Did you turn it on its side at all during transport?

No it stayed in proper position. May pop it apart to see if i can see anythi g wrong.
Breaker is good.

Sent from my SM-J320W8 using Tapatalk

 

[RI Chevy]

How old is it? Could just be at the end of its life cycle?

 

[Lightning Performance]

youtube is your new friend

 

[merc_man]

How old is it? Could just be at the end of its life cycle?

Think it was baught in 06 or 07.
Just weird it fired up ran good for about 2 mins then buggered up.


Sent from my SM-J320W8 using Tapatalk

 

[RI Chevy]

Maybe the fan is a little gunked up? The shaft could be a little rusted up.

 

[merc_man]

What ever these are. It hums like crazy when turned on.
Fan does not work either.

Sent from my SM-J320W8 using Tapatalk

 

[Fruecrue]

Compressor motor terminals on left, motor overload on right.
Start components will be located elsewhere, most likely a potential relay and start capacitor.
Got a pic of the main electrical compartment?

 

[merc_man]

Compressor motor terminals on left, motor overload on right.
Start components will be located elsewhere, most likely a potential relay and start capacitor.
Got a pic of the main electrical compartment?

Crap just put it back togeather for now.
Will pop it apart after and take some more pics.

Sent from my SM-J320W8 using Tapatalk

 

[merc_man]

From what i could see the little capacitors looked ok on the board. Bo bolging or bursted ones.

Sent from my SM-J320W8 using Tapatalk

 

[Fruecrue]

Have a look at the bottom of the overload for any burning/ arcing.

 

[merc_man]

Some pics

Sent from my SM-J320W8 using Tapatalk

 

[merc_man]

Have a look at the bottom of the overload for any burning/ arcing.

The over load protector looked good under neith. No burn marks.
Any way to test.

Sent from my SM-J320W8 using Tapatalk

 

[merc_man]

Over load

Sent from my SM-J320W8 using Tapatalk

 

[Fruecrue]

The over load protector looked good under neith. No burn marks.
Any way to test.

Sent from my SM-J320W8 using Tapatalk

Continuity

 

[merc_man]

Continuity

I dont know a whole lot about testing sruff. What leads do i put it on and what setting on multi meter.

Sent from my SM-J320W8 using Tapatalk

 

[Fruecrue]

The board will come loose by squeezing the little white standoffs in the front. Look at the back of the board for any burn marks or broken solder joints (particularly behind the large black relay on the board).