MinnesotaJon
Well-Known OPE Member
- Local time
- 10:13 PM
- User ID
- 21108
- Joined
- Dec 5, 2021
- Messages
- 27
- Reaction score
- 29
- Location
- Grasston
Does a 630 super have the same intake block as a 268? Looking at a scored one. Thanks!
630 super intake
- Thread starter MinnesotaJon
- Start date
- Local time
- 10:13 PM
- User ID
- 2250
- Joined
- Dec 6, 2016
- Messages
- 257
- Reaction score
- 975
- Location
- Dryden, ON, Canada
No, the 630 uses the same block as a 266, bolts on the cylinder, then the carb bolts to it, not through bolted like the 268/272.
Last edited:
MinnesotaJon
Well-Known OPE Member
- Local time
- 10:13 PM
- User ID
- 21108
- Joined
- Dec 5, 2021
- Messages
- 27
- Reaction score
- 29
- Location
- Grasston
Thank you I thought this was on the 61-272 chassis. If I can get it cheap enough I will still probably pick it up.
- Local time
- 10:13 PM
- User ID
- 2250
- Joined
- Dec 6, 2016
- Messages
- 257
- Reaction score
- 975
- Location
- Dryden, ON, Canada
Yes, the 630 is a 162 chassis saw. It's more or less a continuation of the 162 itself, it uses the same 48mm bore, closed port cylinder.
I know the 266 cylinder will fit under the filter cover, not sure about the 268, but I believe you will have plug clearance issues with a 272 cylinder.
Unless it's a very late Super, it most likely is a dual coil saw.
I know the 266 cylinder will fit under the filter cover, not sure about the 268, but I believe you will have plug clearance issues with a 272 cylinder.
Unless it's a very late Super, it most likely is a dual coil saw.
Last edited:
