SOLD 395

[JIMG]

Clean saw, came to me as a basket case with a replacement top end, bearings and crank. These were removed.
It now has a low hour oem cylinder, good used oem crank, nachi bearings, and a meteor piston.
Other than bearings and piston this is all oem.
I took out the base gasket and gutted the muffler and enlarged exhaust quite a bit.
$700+shipping.

 

[JIMG]

It is tagged as a Brazil build. The little black plate normally riveted on by the oil cap has been removed.
My understanding is this saw had a catastrophic failure early on in its life and the original owner was given a replacement saw.
I had intended to use this as a backup for my hobby remote milling projects but I have other saws now.
It runs well with the typical fun dirt bike feel to it.
I have only run one tank through this saw so far. I am sure it is still breaking in.

 

[JIMG]

Here's a Video of the saw in hard maple.

 

[Normzilla]

Good price

 

[Lando Griffin]

Hey! I’m looking for a larger saw for milling. What’s freight to MA?

 

[JIMG]

Sold Pending Funds