SOLD 395 XP

[XP for Life]

Have a newly freshened 395 XP I took on trade. I have run 6 tanks through it since I’ve had it. Good runner and ready to make some sawdust. Asking $800 and I’ll pay half of the ride from 48629 area code.

Mike

 

[XP for Life]

Have a newly freshened 395 XP I took on trade. I have run 6 tanks through it since I’ve had it. Good runner and ready to make some sawdust. Asking $800 and I’ll pay half of the ride from 48629 area code.

Mike

Have a newly freshened 395 XP I took on trade. I have run 6 tanks through it since I’ve had it. Good runner and ready to make some sawdust. Asking $800 and I’ll pay half of the ride from 48629 area code.

Mike

 

[huskyboy]

Compression will probably come up a bit when the rings seat.

 

[Muad]

What a beauty. I'm still researching on which "big" Husky I want to add to my stable. Kind of torn between a 288/281xp, 390xp, and a 395xp like you have here.

Want something for running 36"+ bar(s), and for milling. Currently my "big" saw is a ms461 with a 28" B/C.

Good luck, that thing is clean!

 

[TreeLife]

What a beauty. I'm still researching on which "big" Husky I want to add to my stable. Kind of torn between a 288/281xp, 390xp, and a 395xp like you have here.

Want something for running 36"+ bar(s), and for milling. Currently my "big" saw is a ms461 with a 28" B/C.

Good luck, that thing is clean!

Can't go wrong with a 395 for big bar and milling duty. Can tune it fat, oils well, very heavy duty.

 

[XP for Life]

What a beauty. I'm still researching on which "big" Husky I want to add to my stable. Kind of torn between a 288/281xp, 390xp, and a 395xp like you have here.

Want something for running 36"+ bar(s), and for milling. Currently my "big" saw is a ms461 with a 28" B/C.

Good luck, that thing is clean!

Like TreeLife said, you can’t go wrong with a 395 for milling. I put the Granberg mini mill setup on this exact saw. Milled some nice slabs with it. It’s currently setup for 3/8” which is what my ripping chains were.

 

[XP for Life]

Like TreeLife said, you can’t go wrong with a 395 for milling. I put the Granberg mini mill setup on this exact saw. Milled some nice slabs with it. It’s currently setup for 3/8” which is what my ripping chains were.

Taking offers for this solid runner

 

[Woodpecker]

Want something for running 36"+ bar(s), and for milling. Currently my "big" saw is a ms461 with a 28" B/C.

If that's what your looking for, skip right to the 395.