192t vs 193t

[rocco490]

If you could have either a 192 or a 193 brand new which one would you get? And if you know the differences in the engines I havent been able to find much but I heard there different

 

[DND 9000]

The main differences between the MS 192 T and MS 193 T are:

MS 193 T:
2-cycle stratified scavenged engine
Lower fuel consumption
Chain sprocket cover with captive bar nut

 

[rocco490]

Is the 193 stratified engine better or worse for performance or longevity compared to the older 192?

 

[sawmikaze]

I like the 192 better.

 

[rocco490]

I like the 192 better.

why is that? do you think it runs better or something?

 

[sawmikaze]

why is that? do you think it runs better or something?

I hate how low the 193 is rev limited is really what it is..

They're both plastic saws and obviously aren't up to a 200/201 and serve a purpose, I like the 192 better for the speed alone.

 

[lehman live edge slab]

I guess I need to try a 192 I know the 193’s seem to do pretty decent after I open the exhaust, advance the timing and retune the carb after pulling the limiters. I’ve done 4 so far and the owners really like them now compared to what they were off the shelf. But they will never be a 200.

 

[Backtroller]

I really liked the 192tc I had. I opened up the exhaust and advanced it. It spooled up quickly and cut good with a 12” bar. I sold it to a tree crew after I found a 200t and 201t. When I spoke to them this past fall, they were still running it. They’ve been running it about 2 years now.

 

[sawmikaze]

I guess I need to try a 192 I know the 193’s seem to do pretty decent after I open the exhaust, advance the timing and retune the carb after pulling the limiters. I’ve done 4 so far and the owners really like them now compared to what they were off the shelf. But they will never be a 200.

They do ok opened up with a timing bump..i just can't tune em' where id like before they smack off the limiter.

 

[lehman live edge slab]

Just wondering if a 192 coil will fit the 193? Maybe you could get rid of the rev limiter then.

 

[rocco490]

Thanks so much for all the info everyone

 

[dall]

Just wondering if a 192 coil will fit the 193? Maybe you could get rid of the rev limiter then.

i think the mounting holes are different

 

[lehman live edge slab]

Ok I’ve never messed with a 192, everyone local uses 200’s and when some wanted lighter saws the 193’s were already here. Only found a few overpriced ones on feebay

 

[dall]

Ok I’ve never messed with a 192, everyone local uses 200’s and when some wanted lighter saws the 193’s were already here. Only found a few overpriced ones on feebay

ive built a couple and they are not my favorite

 

[lehman live edge slab]

Ok kinda gathered hot much different than a 193 anyway

 

[rocco490]

I like my 192 mastermind did timing advance and a muffler mod. with those few changes it runs good for what i've use it for. keep a sharp chain on it and it does fine