ZERO's latest activity
-
ZERO reacted to dangerousatom's post in the thread Muffler Mods and Increased Decibels??? with
Like.
Chainsawing while in a kayak! That some sketchy stuff, like cutting at night with no lights all while a bit tippsy. . . -
The top and small rear handles are the only ones I see where pipes might be needed. That's due to no room around the muffler to add a...
-
Cut the factory spot welds on a 261c can and opened the outlet. Plan is to drop a piece of metal though a slit in the top to eliminate...
-
This is the 400c muffler I recently did. Simple enough and sounds like a dragster.
-
Depending on how you direct the hot gasses the dB can change. Side exhaust ports placed to the rear of the muffler can seem to be the...
-
ZERO reacted to hacskaroly's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
Dirko HT is highly recommended as fuel, heat (up to 315 C) and plastic safe. You don't need the sealant in the entire notch, just where...
-
ZERO reacted to Clarkbug's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
Thank you! And thanks for the picture, that's helpful. I think on my saw those notches hold the edges of the seals, and the bearings...
-
ZERO reacted to hacskaroly's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
Follow the instructions on the tube, I know others use Dirko, I think I have another brand, maybe Permetex, can't think of it off hand...
-
ZERO reacted to Clarkbug's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
Update after lunch. Pulled the gear off. a 3/8" fitting fit, but only a few threads. That and some screwdriver action seemed to...
-
ZERO reacted to hacskaroly's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
Just put the makeshift tool back on and tap it until it seats. Yeah, the 36/41/51/55s are basically the same thing, just different...
-
ZERO reacted to Clarkbug's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
I actually was just watching those same videos. Wasn't sure if it was the same setup, so Ill need to see what I have for fittings in...
-
ZERO reacted to hacskaroly's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
The thread pitch should be 1/2" pipe thread (if I remember correctly), I have a Husky 55 with that set up and built my own puller from a...
-
ZERO reacted to Clarkbug's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
Thanks for the reply! Here is a photo that I took before I pulled everything apart. You can see the sealant at 2 and 9 by the crank...
-
ZERO reacted to hacskaroly's post in the thread HELP! Poulan Pro PP295 - Air Leak or Carb Issue? with Like.
I have learned when getting a saw with unknown history (use, length sitting without use...etc), I find it best to just go ahead and...
-
ZERO reacted to srcarr52's post in the thread what IGNITION SYSTEM would be the better combo for a 550xp MK1 or 2 build with Like.
Best answer!