ZERO's latest activity
-
@Bill G -
Looks like a 1200B...made by Reed-Prentice...
-
Looking for some info on this supposed Craftsman...maybe model and worth ? Thanks Ernie
-
I haven't followed all the changes they've made, but I thought revboost was phased out after the mk1s
-
Wish we had a Husky dealer. He went Stihl, but this year the local hardware store put in a Stihl section. They just don’t work on them...
-
"I have a feeling there will be issues with the bearings in this series." Does 560 - 562 mkII - 564 still have revboost ?
-
The cylinder and roof are perfectly fine. Other than the plating getting thin beside the port where the loose piece of aluminum was...
-
Also inspect the exhaust port roof for any damage.
-
I’ll measure the gap later this week.
-
Scoring often doesn't accompany this situation. And it can go along time before manifesting itself. All it takes is a heat excursion...
-
There is no scoring, which should happen during a case of the ring being tight. Also, a tight ring gap would show up before a year of...
-
I've seen some Echo blowers pb-403 pb-413 and pb-620's , that the exhaust port was nearly flat on top. High hour landscaper units...
-
I must agree with everyone so far the 572 & 565 are both great saws. They run extremely well stock & with a heavy muffler porting and...
-
If you’re talking about the red plastic caps, I pull them with a drywall screw, trim the tab off and put them back in. I’ve had a few...
-
The needles stay in place just fine with them off, but due to how small the needles are it can be hard to line up a flat screwdriver...
