ZERO's latest activity
-
ZERO reacted to DillonBuck's post in the thread Cold weather-cold starting 550 xp autotune with
Like.
how old is your gas? If there is any chance it was summer blend, get fresh. The ability to evaporate in cold temp is the basic... -
ZERO reacted to legdelimber's post in the thread Cold weather-cold starting 550 xp autotune with Like.
Does the heating element just feed strait from the source coil? When switched on. How many watts is the heat draw with a cold element...
-
^Sounds logical. A dragging clutch, especially on a concrete saw, can cause the same problem, depending on the ignition timing curve at...
-
ZERO reacted to Stump Shot's post in the thread Cold weather-cold starting 550 xp autotune with Like.
I think it's just the extra drag on the cold engine that is impeding starting, as the saw needs to hit 800 RPM to generate enough spark...
-
ZERO reacted to hacskaroly's post in the thread Cold weather-cold starting 550 xp autotune with Like.
Like others have said, I don't think the heat side is stealing any power from the spark. The heated lines are fed by a generator that...
-
ZERO reacted to Stump Shot's post in the thread Cold weather-cold starting 550 xp autotune with Like.
I wouldn't think the heat being on would affect it either, however, I did run across a 550XPG MKII that had that very same affliction...
-
Random ideas: Does it blow smoke when it finally starts? How old is your fuel line? I feel like they don’t seal all that well...
-
ZERO reacted to brushwacker's post in the thread Cold weather-cold starting 550 xp autotune with Like.
The other day at about 20 degrees after pumping the purge bulb about 6 or 7 times and normal choke procedure I pulled it about a dozen...
-
I would not believe the heat switch would make a difference to the spark plug, it’s a separate system. I have the same issues with a...
-
ZERO reacted to mainer_in_ak's post in the thread Cold weather-cold starting 550 xp autotune with Like.
It is currently 30 below zero here in interior Alaska and my echo cs 620pw and cs 590 are starting up no problem past few days. The cs...
-
Finally got a picture.
-
Still rocking my 80s Binos.
-
Found it in my new/future shop.
-
No pictures, but my fairly new Heyco screwdrivers still say W. Germany.
-
Well, not a tool, but a item heavily utilized by the German working men back in the olden days. A "Henkelmann" - a thermos can for...