ZERO's latest activity
-
Hey guys just picked up a super clean ms661 made in 2024, it has the standard carb (kinda wish it was mtronic)…. Anyway just curious... -
There will probably be another article which will be titled: "Frontier supercomputer uncovers why worn chainsaw chains aren't as...
-
Wonder what changes AI + supercomputer driven future will bring to the table...
-
Old thread, but did anyone find out if just leaving the baffle and enlarging the existing port is about the best you can do??
-
ZERO reacted to tree monkey's post in the thread 661 muffler mod progression w/thermocouple with
Like.
i remove the baffle and add 1 port for long bar and 2 ports for short bar -
I measured the rim tonight at each of the seven points where it steps in. All checked the same.
-
LoL maybe 🤔 I’m not laughing at ur comment but how we are all spit-balling this. Have you swapped out the chain yet? That’s were I’d...
-
In that case as the rest of the chain stretches the whole thing will be More uniform?
-
My money is on a tight bunch of rivets or sloppy holes on the chain. A bearing, rim sprocket or nose sprocket will not give that much...
-
Both pieces or just the rim?
-
Called a local shop and will be grabbing a Oregon to see if that fixes. I’m going to measure the Chinese one tonight and see how it...
-
YES Both 3/8" but is one a LP/Picco? Pull the (I assume it is) rim and chain and see if th chain sits/saddles in the rim sprocket all...
-
Lots of good advice here. You might also check the chain drivers to make sure there are no burrs.
-
I've seen it with no-name rims. Calipers confirmed out of round between inner spline and outer rim. SMH
-
I had this problem and it was the chinesium sprocket