ZERO's latest activity
-
Punctuation is free. I can’t figure out what you’re trying to say. The post you quoted originally had some more content that was deleted... -
ZERO reacted to huskihl's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with
Like.
Other than the side plate staying sharp a little longer being at 80°, yes. Standard chain works fine for milling, noodling, or cross cutting -
ZERO reacted to Lawless's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I sharpened a very nice like new 91DL 3/8 chain I found in the “box o chains” I inherited from my FIL. It had a little rust in 2 places...
-
ZERO reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Some guys mentioned, over the years, profiling their depth gauge grinding wheel concave, to adjust height, and shape them, at the same...
-
ZERO reacted to Wilhelm's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I use a small OD pink stone in my straight shaft/dremel type grinder on filed rakers. Or recently, I grind them at a 70° angle and...
-
ZERO reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I often set my depth gauges with the grinder, for height, then round them over to the factory profile using a ScotchBrite deburring...
-
ZERO reacted to president's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
well said!
-
ZERO reacted to Wilhelm's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I did it that way with my 36" setup, 5 or so degrees every other grinding. That loop is now dedicated for milling, and a new 115DL loop...
-
ZERO reacted to Junk Meister's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Bob L has/had a many page thread over on AS one comment was kind of an answer. Don't waste a chain away by sharpening it all at...
-
ZERO reacted to Lawless's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
So the only reason to change a chain to 10° for milling would be better finish? Otherwise standard chain is just as good?
-
Ya they get done after the cutter….
-
Looks very nice Awesome
-
looks fine to me
-
Yep 084 cylinder Hows the plating ? Nice find
-