ZERO's latest activity
-
So, I came across this old paper from Yamaha and just wondered if there has been any chatter recently about polybutene similar to this... -
Yes I have tried RA but was not happy with it. It left a golden varnish on my piston. Several oils tested prior with no varnish. But ...
-
Cannot for the life of me figure out the contact spring. If I pull the trigger and push the lever to the full choke position it slips...
-
We have a chainsaw. A few things that were boogerbears in the assembly. The ring compresssor tool works well. The AV rubber grommet...
-
I keep putting some run time on the saw. Weather permitting, I’m going to try it today with a 24” bar and new C85 chain.
-
That is a superb deal you got from them Dan, mine came to 1750€, but it was xpg, and with an xpg wrap handle + spikes. Got 10% off the...
-
Fits betwen 652 and 572 ?
-
ZERO reacted to jacktheripper's post in the thread MCCULLOCH The official McCulloch thread with
Like.
I’ll take that problem saw off of your hands if it’s bothering you too much! -
Today I measured the bore of the cylinder I took off, seems pretty well round and pretty straight top to bottom. My measurements were...
-
ZERO replied to the thread New year….new saw!.Dan as nice as they get 🌝🌝🌝 them chips. 😍😍😍
-
Pm I want to buy the saw
-
The biggest difference between them is that the powerhead is slimmer and lighter on the 42 special compared to the 44
-
What would be the difference between this and a Husqvarna 44 from the 1980s ? Just wondering. Thank you.
-
Sounds like the snow hit Indiana like Most of us. I only got around 4" Folks north of us less. I just grabbed the broom yesterday and...
-
I just got done straightening some sprung bars for Cat 525 and He needed a reason to holler at me (Check on progress with his bars)...