ZERO's latest activity
-
Thank you Kev. I will show pictures of it relieved as I go forward. Time has been the biggest hindrance for me. Hoping to get final... -
I can try, with the welding tip kit when I find it, lol. But, the aluminum oxide is pretty bad. Good thing is the needle seats are not...
-
Bottom drawer of my tool case has been difficult to shut for a couple of years. Pulled it out other day and found 3 tools I've been...
-
Somewhere, lol Found it…on the oxy/acl cart, duh…
-
You have a welding tip cleaning set?
-
I run a wire from a repair tag down into those as far as I can.
-
I can get the larger ones with carb brushes. The tiny, .030 passages into the body of the carb, not so much.
-
By top passages you mean the mix needle passages? Usually corrosion doesn’t affect them as much because they aren’t sealed like the pump...
-
The corrosion is localized to that one section. I wire brushed a lot of it off after quite some time in the sonic tank. But, how much is...
-
This Remington SL11 was pumping a lot of air and very little oil. The pickup in the tank was pretty plugged and the line from the oil...
-
Whether to save it or not depends on how rare the carburetor is. Hitting that with a sandblaster and polishing the face would bring it...
-
Hmm....don't think I can salvage this one :( Way too much corrosion.
-
Well...it seems to like a fleese filter rather than the fine mesh. 10-10,5 in the cut without any pressure added. 18" maple...
-
Some Pioneer parts came in.
-
they look normal to me. can try a nos filter as well.
