ZERO's latest activity
-
You said “Patient” 🤣 Good to see this Doc! -
This won’t be a speed build by any means, so I hope you’re all patient.
-
Seems like we need a build thread here. It’s been too long and traffic has slowed, I hope it gets busier. I’d doing a good friends...
-
That was where I had to actually buy some tubing. I moved the plastic bracket/mount up the tube as far as I could then cut down the rest...
-
Did you just cut and weld that last section? Came out amazing.
-
That is most outstanding!
-
Finished the 026 wrap up this morning.
-
It held at .5 for about 10 minutes. It’s holding pressure but pushing fuel out of the impulse hole.
-
How fast is it leaking? How many seconds from .5 bar down to .4?
-
I hooked the pressure tester to the fuel line and it wouldn’t build any pressure. The fuel line is new OEM and the vent looks clean. The...
-
You can test to make sure the tank vent is operating with the pressure tester. The vent is located under a small panel on the clutch...
-
I just tried an aftermarket carburetor and it was leaking from the same spot.
-
Normally a leak there means a perforation in the pump diaphragm.
-
Yes, it was changed
-
That‘s the impulse circuit. Did you change out the pump diaphragm?
