ZERO's latest activity
-
ZERO reacted to bwalker's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with
Like.
Crack pipes are the invention of guys like Ironhorse. -
ZERO reacted to bwalker's post in the thread Stock and Modded “can” mufflers vs pipes - an honest discussion without any attitude with Like.
All of those factors very with RPM. Stinger diameter controls how hot the pipe snd engine runs. To small and you will burn it down, to...
-
On a totally unrelated note, I am looking for any Homelite or Efco saws in the John Deere green color scheme. They need to be good or...
-
Captain, there be a doorway here... Looking from the kitchen/break room in the current building into the hallway. I can now pass...
-
Most likely, cashed in for scrap, done it myself for plenty of large expensive manufacturing tools.
-
Who knows? Lockheed had to cut up the tooling for the SR-71 so no other government could get access to it. Maybe Dolmar did the same.
-
Wonder where the tooling and stuff went to? Surely not a dumpster?
-
Old Porsche engines too
-
I think that is standard practice with Lycoming aircraft engines. Thread and sealant.
-
I used to use white cotton thread to help seal snowmachine engine crankcases. Put the sealer on and lay a single thread in the center...
-
Time to dredge this thread up again! I finally have a need to put my 044 to work cutting some charity firewood and I need to get this...
-
Be careful on max oil setting or you will run out of oil before gas. I believe it’s been mentioned in here a few times that you can...
-
@chipper1 does that so he can take a break sooner 👍👌😂
-
Hey buddy I can send you some files to try when you get up and going. I have a lot of files for wood cutting also.
-
I found 4 different kits, 300781 and 322709 are for the PM 10 Series saws with the H/L needles coming all the way to the side of the air...