ZERO's latest activity
-
Most members couldn't fathom the miles my DAD could get out of a foot of Bailing Wire. The same goes for bars. If he did something... -
@srcarr52 😁
-
I assume you have checked the Tube ... SCAR did one 13 yrs ago the comments are certainly worth reading. I searched "Hard facing...
-
I put a straight edge against the side of the bar and a cutter, the cutter tipped sideways enough that it did not hold the straight edge...
-
Is there a CBN raker wheel for USG grinders?
-
Has anyone used a Stihl Rapid Duro3 chain for tree stump cutting?
-
If my 50-60cc saws see anything over about 2/3 the length of the bar (i have 5 in the 50-60cc range, 026, ms261, ms362, and husq...
-
What are we talking here Clutch or Flywheel as you stated at the start it looks like clutch. Either one I just take them up with a...
-
If it's cast onto the flywheel use a small square needle file. I mark the key with a black marker so I can see how much im taking off...
-
ZERO reacted to bogieboy's post in the thread Ms362 base gasket delete and timing advance? with
Like.
Crazy to see the evolution of thes motors, as when i ported my 044, with a base gasket delete, its still over .030" squish since i dont... -
ZERO reacted to singinwoodwackr's post in the thread Ms362 base gasket delete and timing advance? with Like.
Same here, 2 different builds
-
ZERO reacted to Sloughfoot's post in the thread Ms362 base gasket delete and timing advance? with Like.
I'd start with taking 1/3 off, if someone with experience with it didn't advise otherwise before I found the skinny file. You can...
-
ZERO reacted to bogieboy's post in the thread Ms362 base gasket delete and timing advance? with Like.
Gotta check squish, when i rebuilt my ms362 i was going to gasket delete it... reassembled with the new piston (aftermarket for what its...
-
ZERO reacted to FederalQ's post in the thread Ms362 base gasket delete and timing advance? with Like.
The key appears to be part of the flywheel like the 361. The stock base gasket looks to be 0.5mm or .020“.
-
ZERO reacted to SawAddictedFarmer's post in the thread Ms362 base gasket delete and timing advance? with Like.
Is the key on these built in or separate?