ZERO's latest activity
-
What grinder are you using? -
ZERO reacted to singinwoodwackr's post in the thread Presets for Spinning and Breaking Chain with
Like.
Id take a 25pk bag if I can find one :p My supply from 20+ years finally disappeared. I don’t do that much 404 but like to have parts on... -
ZERO reacted to Maintenance Chief's post in the thread Presets for Spinning and Breaking Chain with Like.
No ,I don’t need any . I might have some pre-sets . At 50" sounds like you need 2 sets of them?
-
On the carburetor, while yes it takes extra effort to remove by pushing the little tab on the bottom to release it. However, when it...
-
This is one thing I like that Husqvarna did, I can work on a 36 all the way up to a 2100 and they are basically the same, I was really...
-
There was an issue with the cooling and the slant - back cylinder was supposed to alleviate this issue 🤷… The spacers on the cylinder...
-
Some thoughts, takeaways and questions answered... For starters the 562XP was computer CAD designed to be powerful, lightweight and...
-
I just stopped cutting firewood! :rolleyes:
-
The older one becomes heated handles are a nice option to have in cold climates.
-
Technically, only on Dolmar topics that I have encountered & dealt with myself! :roto2nuse:
-
Hmmm...I figured you were a walking Dolmar wiki 🤣
-
No clue. I have 2 "H" Dolmar's and don't use them. :rolleyes: Also, neither is a large frame gal.
-
I think I have it figured out thanks for all the help gentlemen! Goes from generator to switch, switch to tank heater, tank heater runs...
-
There should be some stanchions cast into the flywheel side of the case where the generator mounts for starting the wiring. It looks...
-
@Wilhelm do you have any information for this? Not sure how close it is to a Husqvarna, but on my 272, it starts at the generator...