ZERO's latest activity
-
Fixeded. :) -
I'm assuming that your saw has .325 on it because that's what they come from the factory with. You can convert it over to picco with a...
-
time for a ms261
-
The only difference between the green and yellow (aside from various cutter profiles) is that the green chain drivers have a small hump...
-
Not that I have any strong points - but my weakest understanding when it comes to saws has to do with chains, so I pretty much have no...
-
What chain size? You may be able to improve performance with a different type of chain on the bar you have.
-
OK- thanks for the input fellas- i will just keep the 18 on it
-
No- it has two
-
You can get an aftermarket bar ( cannon ) for it in Picco. Stihl doesn't make a 3005 mount bar in a 20". It's not gonna oil it well, I...
-
I'm not familiar. Does it have a single bar nut?
-
I have a Stihl MS 251 that is VERY slightly modified ( timing advance and gutted the muffler somewhat ) and has noticeably more power...
-
The bearings are not a press fit per se in the housing, they are pressed onto the crankshaft. They slide into the crankcase when the...
-
I went to install my crankshaft and bearings into the side cover today, and it's not a press fit anymore. It's not sloppy per se, but...
-
There are ways. Just need to clearance the intake partition and slot the lower muffler bolt holes, same as all 5 series
-
In my opinion the cylinder is slanted to help give the saw the lowest profile possible and squishing everything together. That is what I...
