ZERO's latest activity
-
Yes, I have two different sized Oregon anvils. I have accidentally used the larger anvil a couple of times and you find out right away... -
Are you using a different size anvil for LP chain vs big 3/8? They require a different size.
-
There's Philbert With the instantaneous on demand content! Good info my friend Regarding people seizing links, oddly I've probably...
-
Oh yeah...I have repunched my fair share of links :D
-
Or, go too far and seize the links 😒 Then, start over…
-
I can vouch for this, the most problems I have had were with the 3/8 picco / low profile, I have to take more time with it than with 3/8...
-
The shape of the spinner anvil can be a factor. On A.S. some guys commented on problems spinning 3/8 low profile (‘Picco’) presets...
-
Good info guys. @hacskaroly Aside from wanting them to look factory, drag is my main concern (albeit maybe moot). Unless completely...
-
Regarding the first question. unless the number of drive links is divisible by 4, you will end up with either a blank space (odd DL...
-
ZERO reacted to foresterntree's post in the thread What is a good price for a used 372xp and what to look for with
Like.
I like the comparison/description Robin gave a couple of years ago about the 272/372… -
Well, I dragged that 372 out of hiding and followed Treemoncky's video. When it came to doing the upper transfers with a dremel I could...
-
ZERO reacted to jacktheripper's post in the thread Preparing to port first saw - which one, and what method? with Like.
Also, I’m at roughly 6000 feet. So that 150 psi comes out to roughly 176 at sea level
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with Like.
What's the usual, around 10lb increase?
-
ZERO reacted to Ketchup's post in the thread Preparing to port first saw - which one, and what method? with Like.
Cabers take 5-10 tanks to break in, but if you’re at 155 you probably won’t hit 170 after break-in.
-
ZERO reacted to Sloughfoot's post in the thread Preparing to port first saw - which one, and what method? with Like.
I haven't seen bunches of them , but the work saw recipes from you accomplished porters I have found are very similar as far as timing...