ZERO's latest activity
-
Will be a fun project with my fil over Thanksgiving while the hens cluck. -
May just do it again. You could rebuild the top end. Get it running and be ready to kill it if it takes off on you. With it running...
-
Ok I'll go back through onan's thread and tear it down some more. Thanks. Life got real fukkin busy in a hurry around here
-
The 350 does not need to be split and is not a clamshell design per say. You’re can remove the flywheel, clutch, cylinder and pull the...
-
I don't let him work long, or in the heat. He stays on top of his chains. Are you saying the top end rebuild may not fix the problem...
-
Use 120g Emory till it’s gone. Then, go back over the entire interior with 220 and 320. 500g is a complete waste of time.
-
Yeh, for it to do that with 50:1 it 'd have to be running long and hard on a hot day with a very dull chain. May not do it then.
-
It was most likely an air leak not your 50:1 mix. I do favor 32:1 now days though after talking with the pros on here.
-
To make sure I'm following, the jug is the cylinder, the sandwich is where the metal part of the crankcase meets the two plastic sides...
-
ZERO reacted to tallgrass_coyote's post in the thread Anyone ran the newest ms261cm for a few years now?? with
Like.
What do y'all mean recalibration? I just got one a few months ago want to know all there is -
ZERO reacted to Khntr85's post in the thread Anyone ran the newest ms261cm for a few years now?? with Like.
Nice that’s what I figured as long as she doing fine no need change nothing..
-
ZERO reacted to hacskaroly's post in the thread Anyone ran the newest ms261cm for a few years now?? with Like.
No, you should not have to unless changing major components and it will have to relearn its boundaries. I am sure it may happen that one...
-
ZERO reacted to Khntr85's post in the thread Anyone ran the newest ms261cm for a few years now?? with Like.
Have you ever seen one that needed recalibrated that you didn’t replace piston in…just curious because I have had mine maybe r years or...
-
ZERO reacted to hacskaroly's post in the thread Anyone ran the newest ms261cm for a few years now?? with Like.
I have done it several times for mTronic saws I have worked on, especially if I change out pistons/cylinders. Easy process, it does what...
-
ZERO reacted to Khntr85's post in the thread Anyone ran the newest ms261cm for a few years now?? with Like.
By the way have you guys ever did the recalibration, I never have I haven’t seen the need process seems simple..