ZERO's latest activity
-
Keep going. Have to to remove ALL of the transfer. You're gonna be at it a while with 500 grit. After it's gone hit the bore with red... -
Keep sanding if the spot gets bigger it's junk if it cleans up more might be ok
-
That’s definitely aluminum. Either transfer still on the plating or no plating.
-
-
So I hit it with some 500 grit, I can definitely feel a low spot with my fingers here below, and also above, the exhaust port. Not sure...
-
Thanks, head is still spinning a bit.
-
Kit the carb, use a 372 intake clamp. New fuel line. Clean up the stock jug and get a meteor piston. I had a quad port 45mm hyway jug...
-
Congrats on the babies! It's always hard to tell from photos, but you might be able to salvage that cylinder. With a saw that old, a...
-
I’ve seen worse cylinders. Run some sandpaper over it and seem how much is aluminum transfer that comes off.
-
Congrats!!
-
Okay, cylinder and piston are out. I think the cylinder is f'd but I defer to the experts. It's a 45 with the dish top. This thing...
-
Update the intake boot clamp to metal if it does not already have.
-
but they did not get 1000 hours out of a saw with one horsepower per kilogram or better.
-
No mosquito bites, at least.
-
ZERO reacted to hero_n6600's post in the thread Accelerator Pump O-Rings (Carburetor Model Look-Up) with
Like.
Ok, finally has my FS52 Walbro WT carburettor's piston pump oring's part number which is 1120 122 3600, ordered that from Stihl dealer...