High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

ZERO's latest activity

  • ZERO
    ZERO reacted to EFSM's post in the thread Husky 350 with Like Like.
    If it wasn’t a Husqvarna, I’d say the plating is fine, but their plating isn’t always the best.
  • ZERO
    ZERO reacted to 59billy's post in the thread Husky 350 with Like Like.
    This might give you a few ideas.
  • ZERO
    ZERO reacted to hacskaroly's post in the thread Husky 350 with Like Like.
    It's possible that he might have loaned the saw out and someone else boogered it up. Looks like it might have been on of those where...
  • ZERO
    ZERO reacted to hacskaroly's post in the thread Husky 350 with Like Like.
    Yes, worth repairing! If you pull the cylinder off and check, you might be surprised, there might be minimal damage if any on the...
  • ZERO
    ZERO reacted to ammoaddict's post in the thread Husky 350 with Like Like.
    Yes. Those are good little saws. Some people put 346xp top ends on them.
  • ZERO
    ZERO reacted to tallgrass_coyote's post in the thread Husky 350 with Like Like.
    My Grandpa came over this weekend gave me a husky 350 that is too much saw for his age. Said last time he went to use it he couldn't get...
  • ZERO
    ZERO reacted to Faduperis's post in the thread HELP! Mall 1mg with Like Like.
    Quincy
  • ZERO
    ZERO reacted to SawAddictedFarmer's post in the thread So what did you do today? with Like Like.
    I got the tractor almost done. Hopefully one trip to Ace and another couple hours and I'll be driving it out.
  • ZERO
    ZERO reacted to drumbum's post in the thread So what did you do today? with Like Like.
    Well sir,......I repaired some solder pads on a 3bx this morning and listened to a couple sermons. Then I finished modding a three...
  • ZERO
    ZERO reacted to tree monkey's post in the thread treemonkey stuff with Like Like.
    around 6deg in port open duration
  • ZERO
    ZERO reacted to tree monkey's post in the thread treemonkey stuff with Like Like.
    yes the stratto port timing changes the same as the intake port timing changes. i consider it all intake as some of the fresh air mixes...
  • ZERO
    ZERO reacted to Fabulous's post in the thread treemonkey stuff with Like Like.
    Obviously, …. my question (addressed to Mr Treemonkey btw) was what effect , if any , would this have on the saws performance. Just...
  • ZERO
    ZERO reacted to bwalker's post in the thread treemonkey stuff with Like Like.
    Of course it changes the timing if the strato cycle. The intake is moved lower and the strato cutouts in the piston stay the same.
  • ZERO
    ZERO reacted to Fabulous's post in the thread treemonkey stuff with Like Like.
    My question to you Mr. Treemonkey (and hope you ate your wheaties this morning) based on your experience, is this: when we lower the...
  • ZERO
    ZERO reacted to Fabulous's post in the thread treemonkey stuff with Like Like.
    The above animation gives a nice view of how the stratos engines operate. Though a Husqvarna is shown I am certain the STIHL version...
Show older items
Top