ZERO's latest activity
-
Welcome to the forum. Lots of info here and very knowledgeable folks here. I may have a new std piston, But before you put a std piston... -
I have 69241 (+0.010") and 69242 (+0.020") piston assemblies that are used with the 69408 (1/2") wrist pin. That's my only...
-
The duration of the freeport is probably not long enough to affect it measurably.
-
I wouldn’t think it would matter
-
It does. Could intake air freeport and drop crankcase pressure before there's back pressure from the muffler or maybe get scavenged by...
-
The exhaust side of the crankcase should have fairly neutral pressure at TDC, probably slightly positive instead of vacuum, due to the...
-
I don’t really know that it’s a thing. With a big enough hole in the muffler there’s not much back pressure to speak of 🤷🏽♂️
-
Good to know. I'll run it without it and leave it as is if it runs well. At some point I'd think there could be too much. How would...
-
I wouldn’t worry about free-porting on the bottom. Anyone that’s done it says those are some of their better running saws. It’s better...
-
Dealing with a few little things. Janky on/off switch, stuck chain tensioner, muffler mod, .060 of freeporting. Thanks for asking
-
ZERO reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with
Like.
Well how’s it run ? -
Yup, got the 262 confused with the 266. Still, I would not mind tearing into a 262.
-
262 is a completely different animal :p
-
Is this maybe because of the non vl vs vl? Guess I’ll need to inspect the cylinder to see if I can figure out a part number to cross
-
Pretty nice mustard yellow Echo 701 I picked up a couple months back.