ZERO's latest activity
-
I think it’s more important now than ever to run 40:1 or better with modern saws. -
It's fine in the cut. Out of cut and idle is like it's running out of fuel all the time. Something that bothers me personally.
-
Thanks to this thread I have gotten my act in gear and rebuilt the pump on this 5 gallon stainless steel Indian Pumper that was long...
-
@EFSM - I simply made some additional adjustments to the L adjustment and it seemed to work O.K. I also showed the owner how to use the...
-
I suspect in this endeavor that the race in question be a prime factor in what does what. It could prove to be a tough challenge with a...
-
Did you ever get this saw sorted out? IIRC those carburetors have an accelerator plunger. When the oring is bad on it weird things happen.
-
Your not wrong. Those might be 025C with primer blub. But no MS250 as I know of. Some 025 have cylinder with decom boss but not tapped...
-
ZERO reacted to 67L36Driver's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
I need guidance on an aftermarket 066. This thing has too much compression and spark advance for a skinny 80 yo to start. Or anyone... -
Hard to pull over at age 40 is much different than hard to pull over at age 70...
-
I finished up on my latest PM 10-10 today.I went to take the old fuel line off the carb & it broke in half just by putting a pliers on...
-
Some old ads I came across
-
ZERO replied to the thread HUSQVARNA HUSQVARNA THREAD.Greg that would be the specialty of our good friend Steve @Stump Shot . Maybe he can pull her out at the upcomming GTG. Steve's 372OE...
-
ZERO reacted to Bill G's post in the thread SOLD NEW Stihl 661 Arctic with 3/4 wrap handle $1495 with Like.
Saw shipped Tuesday and delivered Thursday. Still a few more here that can go out Tuesday
-
I’ll take it for $600 shipped, wait what?
-
If you're not first, you're last I always say