ZERO's latest activity
-
Almost a direct bolt on. I had to rasp a ~1/4 deep crescent out of the bottom lip of the filter cage for it to clear the intake horn... -
does the max flow filter just bolt right up on a 361? I’ve never seen or ran a 361
-
The standard/original Duke's chain is a copy of the Husqvarna Xcut. It has a pronounced top plate "lip" and is very aggressive right...
-
Does anyone have a blue label and standard to post a photo comparison? I’m still holding my breath for a semi chisel but I’m open to...
-
I managed to get ahold of a service manual and Stihl shows the primary reading to be 1.5 - 12k. No spec on the secondary (red terminal...
-
I managed to get ahold of a service manual and Stihl shows the primary reading to be 1.5 - 12k. No spec on the secondary (red terminal...
-
This is an early CDI: This is a M-Tronic: You can't ohm out between the primary and secondary because the circuit board is in between...
-
I’m trying to verify that I actually have a bad coil on this saw before I spring for the new part, here’s what I have done so far...
-
Kudos to @Red97 Ask away in the comments to vote on what you want to see tested. This thing should knock the socks off the 362 it is...
-
Sent you a PM, got crankcase coming in
-
No thanks I have been in those woods and on the mountain sides, not for me.
-
What blows is that they’re not here in the USA to be “bought’n”
-
Worse yet it sucks and blows, sucks in fuel and blows out exhaust.
-
Does the ms 400.1 still blow or is it ok now ?
-
I don't know, but the power curve was impressive. Very wide curve.
