ZERO's latest activity
-
EDIT: ... without losing power! -
I do too. Can't stand an obnoxious saw screaming at me all day. I wish I could figure out how to make ported saws even quieter than stock.
-
Yeah I would have got a ms241 but like ya say ya can't get em anymore. And yeah as far as muff mods go my main goal is not increasing...
-
He didn't make mistakes, just happy little accidents
-
While painting walls and ceilings today I thought to myself, "I wonder if Bob Ross painted a Happy Tree to draw attention away from his...
-
New Ms661c Arctic 3/4 wrap from Bill G who by the way is a great seller and its going straight to Mastermind to work his magic!!! Thank...
-
It is ridiculous we cannot sell them here .......unless you are Amazon or eBay.
-
The piston, ring and jug all came in the same meteor kit so you would hope the ring would be ok. I'll check the bot clamp again when I...
-
Yes I first chased several air leaks then found the new ring somehow ended up being pretty high gap even though I feel like I checked it...
-
@Shane¹ just recently went through some issues with a 350 that I had ported a cylinder for. Sounds like some of the things you found...
-
Yeah its very similar to how this is behaving, will run and cut great for one cut or so then start dieing. If I idle for about 15...
-
OEM parts? Yes except the riser Did you square off the riser? No I had no means to do this, gave it a basic measure with calipers and...
-
I just looked back at the original post. The other thing you have to do on this conversion with a 346 cylinder is shorten the cylinder...
-
On every single 350 I have built, the riser was nowhere near flat. Good call on that one.
-
Here's a 346xp hybrid I did that had the impulse blocked, easy fix but a PIA.
