ZERO's latest activity
-
My thoughts: OEM parts? Did you square off the riser? Clearance the PTO side ribs on the case? What bearings/seals/sealant on the bottom... -
No, an excessive gap will hurt the impulse signal to the carb.
-
Hmm no I didn't, wouldn't this mostly effect compression? Intake boot was in good nick when I did the build.
-
Did you check the end gap on your ring before putting the cylinder on? If not, pull it down and check that. This will give you a...
-
Just completed a 340-346/353 conversion. Meteor piston and jug, ported muffler, no other porting. Left the carb but did a rebuild...
-
-
Dang! Lotta work in that there 500i. I like your observations on better airflow and slightly rougher ports. Same with water. One of the...
-
-
-
@tree monkey That is a lot of work you do to open up the lowers on the 500i! Kudos to you for going the extra mile.
-
I work with fasteners that the company has switched back and forth with aluminum daily. Why tf??
-
Cool videos, I like the detail. How do the 500’s stack up against the 462’s, both ported?
-
-
-
He has mine now, excited for this one!
