ZERO's latest activity
-
I'm going to cut cedar tomorrow. I am bringing a couple saws but I will have different roles for the 545 and 550. I will have the... -
Without AT keeping saws running that otherwise, shouldn't have been, the heat wouldn't have been so excessive. It did its job too...
-
ZERO reacted to lehman live edge slab's post in the thread Couple of my 545/550mk1 builds with
Like.
Pretty sure regular carb wouldn’t fix vapor lock/hard start because of excessive heat in air box. My thought is if they could have fixed... -
I only have experience with the 50cc platform. I am also putting AM muffler's on them because the baffling sits on the roof of the...
-
ZERO reacted to lehman live edge slab's post in the thread Couple of my 545/550mk1 builds with Like.
Yes muffler mod, well apparently husky figured the only way to “fix” was to completely redesign the whole saw and then modify the...
-
Is the saw muffler modded as well? I think looking at the differences between v1 and v2 gives us some great insight to what they found...
-
ZERO reacted to lehman live edge slab's post in the thread Couple of my 545/550mk1 builds with Like.
I used the same tape 2-3 years ago on a 562 mark 1, it helped but by no means cured it completely of the hard warm starts. Also opened...
-
Once they lose compression the idle is the first to go. I would replace the piston ring.
-
I have one that would not idle, start and wot were normal. I tore it down, didn't find an obvious airleak. It is still safe and sound...
-
Don't overthink airleaks. Be thorough down to the crank seals, but don't worry about splitting the case if the crank shaft is tight and...
-
I have some to build, any building tips? things to watch out for? Porting suggestions. the package was the right size but had gremlins...
-
After a couple of weeks with very little activity, some progress was achieved this week on Phase 2. The area in the back was prepped...
-
When it gets hot and dies, pull the plug. If its wet, its flooding. If its dry, ground the plug to the cylinder and see if you have...
-
Sounds a lot like when a saw if flooded, pull about 25-30 times to thin down the fuel mixture in the cylinder until it burps a few...
-
Are you sure the compression is good? What you're describing sounds like low crankcase compression, due either to bad rings or a worn...