Woodslasher's latest activity
-
Woodslasher reacted to Rallyeguy's post in the thread MCCULLOCH The official McCulloch thread with
Like.
For those of you with the big iron... Just added larger stencils for 36" and larger McCulloch bars to my store... -
It's alive! I pulled the flywheel off, and the timing had went retarded somehow. Re-set the timing and it fired right off. It sounds...
-
Woodslasher replied to the thread Woodslasher's 056/066 hybrid build.@Shane¹ page 1 has a lot of 056 piston measurements.
-
Woodslasher reacted to jacob j.'s post in the thread HELP! Stihl 056 Magnum piston measurements with Like.
The one I have here looks like just a hair under 16mm from the top of the pin bore to the edge of the crown (23.5mm from center of pin...
-
My wife always says I never use stuff that I buy to fix things and they lay around the house. I had to prove her wrong today. I broke...
-
Woodslasher reacted to woodfarmer's post in the thread The forestry and logging pictures thread with Like.
just able to sneak it past the young beech, couple nice maple too
-
Woodslasher reacted to woodfarmer's post in the thread The forestry and logging pictures thread with Like.
So last of logging ‘26. Above zero here now and the rain is to come later this week.
-
I beat the crap out of a g1 long 3/8 flex and never had an issue. I got a g2 version of it and it’s fairly new but it’s been good. I...
-
After saying screw Matco after they had a bad run of ratchets and no parts to fix them I got some snap on dual 80 stuff and the locking...
-
Woodslasher reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with Like.
Morena E Hoas.
-
Woodslasher reacted to ray benson's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning. 37°F/ 3°C going up to 50°F/ 10°C. Light rain forecast for this afternoon. Looks like the heavy rains predicted for the...
-
Woodslasher reacted to Definitive Dave's post in the thread WANTED ISO: 359 Top cover, 056 parts, 038 tank with Like.
I’m slow but found a couple 056 bits 😀 Only 1 of the 54mm top ends and it’s rough but would clean up fine. Box of NOS parts including...
-
Woodslasher reacted to Sloughfoot's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
When the boss isn't around I put such things in the oven under 200 degrees for a while. Seems to harden the paint a little. I don't...
-
Woodslasher reacted to jacktheripper's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Well I shot it with some Stihl grey. Not sure how it will hold up. It probably won’t last. But it looks pretty for now.
-
Edit : Kevin (XS) ported it.
