Woodslasher's latest activity
-
Wanted it to stay put till the back cut was done and only smash the old rotten shed roof a little so I hooked the all purpose vehicle up... -
limb removal
-
I went out and rode around the mountains
-
I am cooking a Hedge post..............
-
Played with the new $74 shoebox size, amazon flux core welder. Very surprised at what it could do without any wire speed control...
-
Installed the extended wear kit on my winter work gloves ….. Stuck a good sharp skip chain on the 066 ….. I hauled a few large...
-
Been great, probably my all time favorite. Muffler did start cracking from the corner of my muffler mod after I tried welding deflector...
-
Lower # than Huskys Oldest listed SKU. Willie Wonka said something like "Strike That -- Reverse it"
-
Mines an early first year production without the added webbing on the bar mount. That’s not been an issue but I don’t use it as a pry...
-
Woodslasher reacted to Maintenance Chief's post in the thread Husqvarna 592xp woes and fixes with
Like.
I thought the case reinforcement was added after the first run of 592xp's came out? Because of the spike breaking that corner off. I... -
The same thing happened on the 385/390. Mufflers were rattling apart and Husqvarna had to make a MKII muffler for the 385/390. The...
-
More fire department 680 pics.
-
"58308" seals from LRB arrived this week. They are really 5/8x15/16 like 0609318TC that Tim noted but I was able to get the one...
-
Lay them on their side and lightly tap the washer down with a hammer. Creates enough clearance that the eclip pops right off. They get...
-
I did get me one those fancy flipper phones though.......................