Wolverine's latest activity
-
Big job -
Wolverine replied to the thread Stihl workshop manuals.Appreciate that. 👍🏼
-
Sent message to off grid er with the service manuals.
-
Wolverine replied to the thread Stihl workshop manuals.@ray benson Can you please send these ms250, ms261,& ms194t shop manuals to @off grid er TY
-
Wolverine reacted to Hoser's post in the thread Firewood thread!!! Let's see what you got!!!! with
Like.
I’ve been getting a little bit of firewooding done. Log piles gone now, started another bush, following a processor and picking the... -
Wolverine reacted to CrystalRiver1's post in the thread Firewood thread!!! Let's see what you got!!!! with Like.
Did a bit of dead and downed scrounging today. This was the results, a mixed litter kinda! The big rounds are 2 yr old red oak and rest...
-
Wolverine reacted to Hoser's post in the thread Firewood thread!!! Let's see what you got!!!! with Like.
I wish. Cheapest I’ve seen here is $17 a gallon
-
Wolverine reacted to Squareground3691's post in the thread Firewood thread!!! Let's see what you got!!!! with Like.
-
Heres some pics of a red oak from the old lumber capitol of pennsylvania aka williamsport. 64"gb some oregon .404 hyperskip 3120 xs 58"...
-
One of many standing dead elms to dump.
-
I use a bore/ plunge cut for forward lean trees or decay at the hinge area. I'd say that one cut for everything is not a good solution...
-
Wolverine reacted to sixonetonoffun's post in the thread Firewood thread!!! Let's see what you got!!!! with Like.
Windfall from my cousin's place a whopping 2 miles for this scrounge. He helped load n unload for bonus points. 5 loads of pine, 1 left...
-
Wolverine reacted to hacskaroly's post in the thread Firewood thread!!! Let's see what you got!!!! with Like.
$5.99 in my area, still not bad.
-
Wolverine replied to the thread Firewood thread!!! Let's see what you got!!!!.Heads up if y’all have a Tractor Supply close. Bar oil is on sale, 4.99/gal near me.
-
-
Not my best stump cut ever, but it got down on target. There was a little punk in this one but I knew that from the bore cuts I made to...
