Wilhelm's latest activity
-
Never seen so many bucks in my life. Crazy year. -
This guy is going full speed to not let her get away,,,,
-
Wilhelm replied to the thread The Metalworking Thread.I may not have used the metallurgy professions/industries correct term, though I believe I did write it properly. I dry processed a...
-
-
I think you meant to say annealed it. Heat it up, hold it for a bit, and then let cool very slowly to remove and hardening.
-
Just got done putting this 143 together and could use the money for some other house projects I have coming up. Pretty nice saw started...
-
But you don’t have to order the whole, $150 (+) vise. The vice plates are actually a wear item, too, so it doesn’t hurt too, have them...
-
Wilhelm replied to the thread Makita exits gas equipment manufacturing.I has got a couple. These are empty spares, got more filled with chains.
-
-
@Wilhelm I will take that blame. Those chain boxes are tough and super handy.
-
Wilhelm replied to the thread The Metalworking Thread.I couldn't get the CR-V Allen wrench cutoff threaded so I tried tempering it. It helped, I got a M10x1.5 thread about 30mm deep into...
-
-
Wilhelm replied to the thread Makita exits gas equipment manufacturing.AL-KO is, to be precise! Solo as it was is no more since 2014. or so.
-
Wilhelm replied to the thread Makita exits gas equipment manufacturing.Stihl has been making most their products in China for over a decade. I wouldn't know for certain though as I buy & use only a couple...
-
-
Definitely not factory as the others above have said. Looks nice though! Is there a shop close that could cut one out of the...
-
Wilhelm replied to the thread Makita exits gas equipment manufacturing.
-
-
Wilhelm replied to the thread Makita exits gas equipment manufacturing.Those are old stock! No new units are being made. And I think there is a deadline set on selling new 2-stroke OPE, possibly even...
-
I woke up to a bunch of reports this morning. He was sending DMs to members who had "want to buy" ads with a gmail address for...
