Wilhelm's latest activity
-
Wilhelm replied to the thread The dogs of OPEforum.Pupper got herself a facial on our walk. She had to wait in the shop for me to warm up some water so I can clean her before going into... -
-
They always had a model for 3/4” chain. Or, you could buy the vise assembly and swap it out on one of their standard grinders. I...
-
Wilhelm replied to the thread So what did you buy today.Got some Salsa dip yesterday, "Hot" & "Medium". Got some more "Hot" today AM.
-
-
Heres one of them
-
For an aluminum wedge, any quality bar oil will do, provided the wedge has been polished to at least 400 grit.
-
This is a related question, and whether it makes a difference if the wedges are used for felling or bucking. In felling, the full wedge...
-
(2) Yellow&Red ones (at left in bottom photo) are 'D' (slightly different tips than my sketch); Orange (Husqvarna?) could have been 'B'...
-
Yes and they have a tendency as you drive one in the other one will bounce out cos there's more lift with a double taper wedge where is...
-
In high school, we would call the one in your top sketch a 'right triangle' (90° corner), and the one in your bottom sketch an...
-
Please Forgive my crap artwork but this is what I was trying to explain This is a double taper wedge has nothing to do with the tip or...
-
You don't have a single taper profile wedge in that picture hard to explain but if it was left sitting on a flat surface the head of the...
-
I have heard different definitions for 'single taper wedge' and 'double taper wedge', along with 'single lift' and 'double lift' felling...
-
Wilhelm replied to the thread Wedge Profiles and Names.I call these "custom". Never knew wedges were such a complex topic! But more to the point, what oil and ratio does which wedge...
-
-
On it. Thanks for the reports.
-
Mods?
