Wilhelm's latest activity
-
Didn’t buy it today… But it arrived today IBC tote full of saws and a few parts -
Wilhelm replied to the thread What's on your bench?.Ya pulled too hard!
-
-
I saw a post in another forum, whete the guy used MAXX grinders for sharpening, and his USG for depth gauges! I see a lot of posts...
-
Wilhelm replied to the thread Dolmar PS-7300 oiling rate.Some of my new spare parts stash goodies. I need to sort and inventory list everything I have. I know I have certain parts but can't...
-
-
Wilhelm replied to the thread KUDOS Dolmar 7900 heated handle wiring.I just stopped cutting firewood! :rolleyes:
-
-
Wilhelm replied to the thread KUDOS Dolmar 7900 heated handle wiring.Technically, only on Dolmar topics that I have encountered & dealt with myself! :roto2nuse:
-
Wilhelm reacted to hacskaroly's post in the thread KUDOS Dolmar 7900 heated handle wiring with
Like.
Hmmm...I figured you were a walking Dolmar wiki 🤣 -
Wilhelm replied to the thread Dolmar PS-7300 oiling rate.My custom made clutch removal tools, three Husky, two Dolmar/Makita. My Husky 365/372 tool does not fit a Dolmar 79xx clutch, I made it...
-
-
I'm weighing up whether to get the oil pump repair kit and the oil pump drive or a whole oil pump with drive to save shipping from...
-
Wilhelm replied to the thread KUDOS Dolmar 7900 heated handle wiring.No clue. I have 2 "H" Dolmar's and don't use them. :rolleyes: Also, neither is a large frame gal.
-
I think I have it figured out thanks for all the help gentlemen! Goes from generator to switch, switch to tank heater, tank heater runs...
-
There should be some stanchions cast into the flywheel side of the case where the generator mounts for starting the wiring. It looks...
-
Wilhelm reacted to hacskaroly's post in the thread KUDOS Dolmar 7900 heated handle wiring with Like.
@Wilhelm do you have any information for this? Not sure how close it is to a Husqvarna, but on my 272, it starts at the generator...
