trooney's latest activity
-
trooney replied to the thread HELP! I'm stumped....For lack of a better term -
-
trooney replied to the thread HELP! I'm stumped....I'll get it tomorrow. Is that like a muffler pic?
-
trooney replied to the thread HELP! I'm stumped....It's not an AM cylinder, it's a KS. First time I've ever had this problem to this extent. I'm hoping it's the ring or cylinder. The only...
-
Just suggesting you eliminate any possibility of unintended grounding. Good luck.
-
trooney replied to the thread HELP! I'm stumped....The kill switch is working. Passes a p&v test. I think it has to do with the compression/cylinder. I'll find out once I put on Steve's...
-
trooney replied to the thread HELP! I'm stumped....Yup
-
trooney replied to the thread HELP! I'm stumped....Read the first post...jeesh. The flywheel key is intact. I'll be putting on the cylinder I got from Steve. Something is wrong with the...
-
Check that you didn’t shear the flywheel key. Quite easy on the model. When mine sheared, I had a saw that was doing all sorts of...
-
Heck, even carburetors can warp after a time.
-
trooney replied to the thread HELP! I'm stumped....The problem is getting it running, and it wasn't flooded, just gas from trying to get it started. I'll try the oil method and hopefully...
-
Like Steve said. I think that my issue has been not running new rings hard after putting crosshatching in the cylinder with a dingle...
-
Oil. Then once you get it going, run the pizz out of it to try and get the rings to set in a little bit.
-
They can warp fer sure.
-
trooney replied to the thread HELP! I'm stumped....Well, I pulled that jug off. The ring gap does look a LITTLE large but I'm going to try it with the jug Steve sent me. Gotta get another...
