trooney's latest activity
-
trooney replied to the thread HELP! I'm stumped....Got it -
If your pulling the jug back off, I'd be checking it for out of round or taper as well. Can probably use the ring at various points down...
-
Check your front porch, it should be there.
-
Weird one for sure my friend. Like was mentioned. About .010 - .011
-
I thought of another problem that could cause no start .I experanced this very same thing on first a 2100 Husky and I think recently on...
-
trooney replied to the thread HELP! I'm stumped....Yeah, I did a p&v on it and it was fine. Maybe the ring? How much gap should I have. I've got the feeling it's with the cylinder...
-
I’ve had strange results lately with compression on both a 272 and an 064. Turned out with both of them that the ring gap was too big...
-
I'm gonna suggest a vacuum\pressure test Tom. If this saw ain't got a strong impulse signal, it ain't gonna run. That divot at the port...
-
ring end gap? cylinder wall glazed or something? just spitballin. i had a 181 cylinder with a groove a couple mm wide all the way to...
-
Does it feel like 110? If so try the tester on another saw. I've had the shrader valves get sticky/dirty. When that is the case they...
-
trooney replied to the thread HELP! I'm stumped....Well, I can certainly say that for a new piston and everything checking out alright 110 is really low. If it was a really used piston...
-
trooney replied to the thread HELP! I'm stumped....Got it to spit once or twice but that's it
-
trooney replied to the thread HELP! I'm stumped....Has the gasket, and yes. It's the one I've been using for a long time. It's pretty accurate .
-
trooney replied to the thread HELP! I'm stumped....Steve is sending me a Mahle cylinder that I'll put on and try. Really weird...
-
trooney replied to the thread HELP! I'm stumped....No, but it's stock KS with an Oem gaskey
