Recent content by Tree Sling'r

On another note, these fixes don’t appear right away. I’ve been finding that it takes a little bit for the saw to adjust before going back to normal.

Maybe just one step at a time rather than a series.

So, I’ve been dealing with this issue, in a few saws I’ve built. Saw was getting too much fuel. Start right up without priming bulb. Idle just fine, but fall on its face when engaging throttle. First thing I did was swap module, same issue. Then… I removed and blew out tank vent to see if it was...

Had one, sold it because I never used it. Well, in need of one now. Thanks, Jasha.

Looking for a nice 372 crank for a friend. Thank you.

Just found one, I’ll edit. Thank you.

Thank you.

I cut palms for the City of Palm Springs about 10 years ago. Very sandy, also a full skip chain will help. They are very pulpy, stringy. Everything needs to be perfect.

So, working on a saw I’ve avoided for years. (Literally built and repaired 1000’s of saws) Just helping out a broke ass friend by putting a piston in his 391. My question: you guys using something like Dirko HT to re-seal the cylinder to the case? I do machine work and use gaskets, not very...

I do not know, this is pre C. Just trying to help a friend out. Thank you.

Looking for a flywheel for a ms441. Thank you.

I got mine on Friday, it’s a nice clean 12” Atlas. Now, looking for a 4 jaw chuck and back plate set up.

PM sent

Wow! Thanks a lot! Great information.

Silly question: how do I know if the quick change post style on the Atlas is AXA or AXO or something else? Will either work? I only used one set up for cutting bases on my Grizzly 4000, cut squish by hand.